KK2 1.5 LCD Flight Controller Board With 6050 MPU & ATMEL 644PA

2,200

In stock

  1. IC: Atmega644 PA
  2. GYRO/ACC.: 6050MPU InvenSense Inc.
  3. INPUT VOLTAGE: 4.8V-6.0V.
  4. AVR INTERFACE: Standard 6 Pin.
  5. SIGNAL FROM RECEIVER: 1520us(5 channels).
  6. SIGNAL TO ESC: 1520us.
SKU: NEPL076 Categories: ,

Additional Information

Additional information

Weight 26 g

Description

KK2 1.5 Flight Controller Board W/ 6050 MPU Board With Atmel 644PA is the next big evolution of the first generation KK flight control boards. The KK2.1.5 was engineered from the ground up to bring multi-rotor flight to everyone, not just the experts.

The LCD screen and built-in software make install and setup easier than ever. A host of multi-rotor craft types are pre-installed, simply select your craft type, check motor layout/propeller direction, calibrate your ESCs and radio and you’re ready to go! All of which is done with easy to follow on-screen prompts!

The KK gyro system has been updated to an incredibly sensitive 6050 MPU system making this the most stable KK board ever and allowing for the addition of an auto-level function. At the heart of the KK2.1.5 is an Atmel Mega644PA 8-bit AVR RISC-based microcontroller with 64k of memory.

Technical Specification

Model KK2.1.5
Input Voltage (V) 4.8V-6.0V
Firmware Pre-installed firmware
Sensors 6050 MCU
Processor Atmel 644PA
Micro-SD Card Slot No
Length (mm) 52
Width (mm) 52
Height (mm) 12
Weight (gm) 26

Review

Cart

No products in the cart.