“Wheel Robot Smart Car Chassis Kits Car Model” has been added to your cart. View cart

“Type-C 4 Port USB HUB 3.0” was added to the compare list

“MORPHO MSO1300 E3 USB FINGERPRINT SCANNER” has been added to your cart. View cart

“Type-C 4 Port USB HUB 3.0” was added to the compare list

“neodymium magnet 3mm*1.5mm(Pack Of 10 Pcs)” has been added to your cart. View cart

“PCF8574 I2C” was added to the compare list

“XL6009 Boost Module” has been added to your cart. View cart

“DC Power Jack Female Plug Barrel Connector” was added to the compare list

“2 Port VGA Switch” has been added to your cart. View cart

“Type-C 4 Port USB HUB 3.0” was added to the compare list

“0-12 2Amp Transformer” has been added to your cart. View cart

“DC Power Jack Female Plug Barrel Connector” was added to the compare list

“Phototransistor” has been added to your cart. View cart

“PCF8574 I2C” was added to the compare list

“USB LED Lamp Light” has been added to your cart. View cart

Compare“Center Shaft (100 rpm to 1000 rpm) DC Geared Motor” has been added to the compare list

“79M12/TO220 Voltage Regulator” has been added to your cart. View cart

“DC Power Jack Female Plug Barrel Connector” was added to the compare list

“HDMI TO VGA CONVERTOR” has been added to your cart. View cart

“Type-C 4 Port USB HUB 3.0” was added to the compare list

“2 Port 200 MHZ VGA Spiliter(Model-VGA 2002)” has been added to your cart. View cart

“PCF8574 I2C” was added to the compare list

“NodeMCU ESP8266 – CP2102” has been added to your cart. View cart

“TB6600 Stepper Motor Driver” was added to the compare list

“12V 1A DC Power Supply Adapter” has been added to your cart. View cart

“PCF8574 I2C” was added to the compare list

Compare“Sound Detector Module for Arduino” has been added to the compare list

Sound Detector Module for Arduino

SKU: NEPL161

Roll over image to zoom in

Status:In stock

Operating voltage 3.3V-5V
Outputs digital switching output (high and low level 0 and 1
Operating current (Vcc=5V): 4-8mA
Microphone sensitivity (1Khz): 52-48dB
Microphone Impedance: 2.2KΩ
Microphone Frequency: 16-20Khz
Microphone S/N ratio: 54dB
Signal output indication
Single channel signal output
Outputs low level and the signal light when there is sound

SKU: NEPL161 Categories: Robotic Components, Sensors & Modules

Description
Specification

Sound detection sensor module for arduino detects whether sound has exceeded a threshold value. Sound is detected via microphone and fed into an LM393 op amp. The sound level set point is adjusted via an on board potentiometer. When the sound level exceeds the set point, an LED on the module is illuminated and the output is sent low.