ESP-12E ESP8266 Wifi Module

175

In stock

The ESP-12E ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all Wi-Fi networking functions from another application processor. This module comes with AT commands firmware which allows you to get functionality like arduino wifi shield, however you can load different firmwares to make your own applicaiton on the modules' memory and processor. Its a very economic module and has a huge and growing community support.

SKU: NEPL012 Categories: ,

Additional information

Weight 850 g
Dimensions 5 × 3 × 2 mm
  • 802.11 b/g/n
  • Integrated low power 32bit MCU
  • Integrated 10bit ADC
  • Integrated TCP/IP protocol stack
  • Operating temperature range : -40 ° C ~ 125 ° C
  • Frequency range : 2.4GHz – 2.5GHZ
  • Operating voltage : 3.0v~3.6v
  • Operating current: Average value 80mA
  • Integrated TR switch, balun, LNA, power amplifier and matching network
  • Integrated PLL, regulators, and power management units
  • Supports antenna diversity
  • WiFi 2.4 GHz, support WPA/WPA2 Security
  • Network protocol : IPv4, TCP/UDP/HTTP/FTP
  • SDIO 2.0, (H) SPI, UART, I2C, I2S, IRDA, PWM, GPIO
  • STBC, 1×1 MIMO, 2×1 MIMO
  • A-MPDU & A-MSDU aggregation and 0.4s guard interval
  • Deep sleep power <10uA, Power down leakage current < 5uA
  • Wake up and transmit packets in < 2ms
  • Standby power consumption of < 1.0mW (DTIM3)
  • +20dBm output power in 802.11b mode
  1. LDR Light Sensor on board.
  2. WS2812 Led on board.
  3. The micro USB connection for power and/or programming.
  4. 802.11 b/g/n
  5. Wi-Fi Direct (P2P), soft-AP
  6. Integrated TCP/IP protocol stack
  7. Integrated TR switch, balun, LNA, power amplifier and matching network
  8. Integrated PLL, regulators, DCXO and power management units
  9. +19.5dBm output power in 802.11b mode
  10. Power down leakage current of <10uA
  11. Integrated low power 32-bit CPU could be used as an application processor
  12. SDIO 1.1 / 2.0, SPI, UART
  13. STBC, 1×1 MIMO, 2×1 MIMO
  14. A-MPDU & A-MSDU aggregation & 0.4ms guard interval
  15. Wake up and transmit packets in < 2ms
  16. Standby power consumption of < 1.0mW (DTIM3)
  17. Access Point and Station Modes.